Waveshare ST-LINK V2 (mini) - STM Programmer & Debugger
|+25 4 % $9.41|
|+50 6 % $9.21|
|+100 8 % $9.02|
|+300 10 % $8.82|
|+500 12 % $8.62|
Mini ST-LINK/V2 on a small single board, an extreme low cost solution for in-circuit debugger/programmer for STM8 and STM32.
Onboard 500mA self-recovery fuse to avoid harming by short circuit
Dual voltage output (3.3V/5V), easy for debugging/programming
Standard USB interface for direct connection to PC
Debugging : run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
Programming : supports FLASH ROM, EEPROM, AFR, etc.
USB2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming
The firmware is upgradable to support more devices in the future
• Supported software
ST-LINK Utility v2.0 (or higher ver.)
STVD Version 4.2.1 (or higher ver.)
STVP Version 3.2.3 (or higher ver.)
IAR EWARM Revision v6.20 (or higher ver.)
IAR EWSTM8 Revision v1.30 (or higher ver.)
KEIL RVMDK Revision v4.21 (or higher ver.)
• Supported devices
All the STM8 devices with SWIM interface
All the STM32 devices with SWD interface