MCP2515 CAN Bus TJA1050 Receiver Module SPI

MCP2515 CAN Bus TJA1050 Receiver Module SPI is a standalone CAN controller module for microcontroller communication. It combines the MCP2515 controller with the TJA1050 high-speed CAN transceiver and uses SPI for communication. The module supports CAN V2.0B and handles standard and extended data frames. It is designed to reduce MCU workload through onboard acceptance filtering and message buffering. The module also includes onboard indicators and separate buttons.

Features of MCP2515 CAN Bus TJA1050 Receiver Module SPI - 1Mbps, 5V

• CAN V2.0B support
• High-speed TJA1050 transceiver
• SPI communication interface
• Standard and extended frame support
• Onboard acceptance filters
• Onboard receive buffers
• Independent key and LED indicators
• Low-power CMOS operation
• SOF signal monitoring

Specifications of MCP2515 CAN Bus TJA1050 Receiver Module SPI - 1Mbps, 5V

• Supported protocol: CAN V2.0B
• Transceiver: TJA1050
• Module size: 40x27x10 mm
• Communication speed: 1 Mb/s
• SPI interface speed: 10 MHz
• SPI modes: 0,0 and 1,1
• Crystal: 8 MHz
• Termination resistor: 120 ohm
• Operating voltage: 4.75V to 5.25V
• Operating current: 5 mA
• Standby current: 1 mA
• Industrial temperature range: -40°C to +85°C
• Extended temperature range: -40°C to +125°C
• Two receive buffers with prioritized message storage
• Six 29-bit acceptance filters
• Two 29-bit masks
• Standard and extended data frames and remote frames
• Data field length: 0-8 bytes
• Three transmit buffers with prioritization and abort function
• One-shot mode
• Programmable prescaler clock output pin
• Selectable interrupt output pin
• Selectable buffer full output pin
• Selectable Request-to-Send input pin

How to Use MCP2515 CAN Bus TJA1050 Receiver Module SPI - 1Mbps, 5V

1. Connect the module power pins to a 5V supply within the operating voltage range.
2. Wire the SPI lines between the module and the microcontroller.
3. Connect the CAN bus lines and configure the required communication settings.
4. Use the interrupt, indicator, or control pins as needed for your application.

More Info

• Onboard power indicator included
• Onboard separate buttons included
• Supports CAN bus communication with microcontrollers
• Compatible with SPI-based CAN bus expansion