LCR-T6 Multifunction Tester

The LCR-T6 Multifunction Tester is an electronic component tester for automatic identification and measurement of common parts. It supports resistance, capacitance, inductance, diodes, transistors, SCR, and MOSFET devices. The tester can detect component type, polarity, HFE output pin, threshold voltage, and gate capacitance. It features one-button operation, a backlit 12864 LCD, and fast testing for quick component checks.

This multifunction tester is designed for electronics, robotics, and repair work where fast component identification is needed. It includes automatic pin detection, automatic shutdown, and low standby consumption. The display uses a 12864 LCD with 128*64 characters. The chip used is Atmega328.

Features of LCR-T6 Multifunction Tester

• Automatic component detection
• One-button test operation
• Backlit 12864 LCD
• Automatic shutdown
• Low-power standby mode
• Fast test response
• Automatic pin detection
• High output accuracy

Specifications of LCR-T6 Multifunction Tester

• Chip: Atmega328
• Display: 12864 LCD
• Display format: 128*64 characters
• Backlight: Yes
• Standby current: 20 nA
• Power mode: Rechargeable Li-Po (Built-in)
• Display screen: 3 x 2.3 cm LCD Screen
• Diode range: < 4.5V
• Zener diode detect area: 0.01-30V
• Transistor detect area: 0.01-4.5V
• Triac range: IGT < 6mA
• Capacitance: 25pF-100mF
• Resistor: 0.01-50MΩ
• Inductance: 0.01mH-20H
• Test time: 2 seconds
• Large capacitor test time: 1 minute
• Battery voltage warning: Under 3V
• Charging input: 5V battery or USB interface

How to Use LCR-T6 Multifunction Tester

1. Discharge the electronic component before testing.
2. Connect the component and start the test with the single button.
3. Read the detected type and values on the LCD screen.

More Info

• Suitable for testing NPN and PNP transistors, N-channel and P-channel MOSFETs, diodes, resistors, capacitors, inductors, SCR, and triac devices.
• It can detect zener diode function and supports self-calibration.
• When the internal battery voltage is under 3V, charging is required before use.