TMC2208 V3.0 Stepper Motor Driver Module (for 3D Printers)

Description
The motor controlled by PWM chopping mode runs more smoothly and avoids jitter. It can effectively avoid the problem of running deviation and fault caused by the chip being too long.
Motor current can be set arbitrarily by firmware. Micro-steps can be set arbitrarily by firmware (up to 256 actual micro-steps),The actual and interpolated microsteps can be combined to achieve.maximum torque. Firmware can dynamically switch stepper motors between stealthChop2 and spreadCycle modes through UART. When the motor is not moving, the standby current of the motor can be
reduced dynamically (through UART).
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures.

Features
Configuration: UART
Microstep: Up to 1/256
Logic Voltage: 3.3V/5V
Input Voltage Range: 4.75-36V
Motor Phase Current: 1.2A RMS, 2.0A Peak
Single-line UART: for Advanced configuration options
Low Resistance: LS 280mΩ & HS 290mΩ, (25°C Typical)