Contents

Interfacing SPP-C Bluetooth to Serial Adapter Module with Arduino

SPP-C Bluetooth Module Features

Bluetooth modules are a type of wireless communication modules that can be added to a project as through serial or SPI communication protocols.

The advantage of using Bluetooth modules is that they are easy to set up and use.

The SPP-C module uses serial protocol for communication.

Note

All Bluetooth modules that use serial communication protocol, support AT Commands, which are listed in the datasheet of each product.

Download the datasheet of SPP-C module here.

SPP-C Bluetooth Serial Module Pinout

This module has 6 pins:

  • VIN: Module power supply – 3.6-6V
  • GND: Ground
  • STATE: Connection State
  • EN: Enable AT Command settings
  • RX: Receive Serial Data
  • TX: Transmit Serial Data

You can see the pinout of this module here.

Required Material

Hardware component

Arduino UNO R3 × 1
SPP-C Bluetooth Serial Wireless Module × 1
Male to Female jumper wire × 1

Software Apps

Arduino IDE

Interfacing SPP-C Bluetooth Serial Module with Arduino

Step 1: Circuit

The following circuit shows how you should connect Arduino to SPP-C module. Connect wires accordingly.

Step 2: Library

Install the following library on your Arduino IDE.

https://github.com/PaulStoffregen/SoftwareSerial

Tip

If you need more help with installing a library on Arduino, read this tutorial: How to Install an Arduino Library

Step 3: Code

Upload the following code to the Arduino board.

 /*
  Modified on March 09, 2021
  Modified by MohammedDamirchi from https://github.com/PaulStoffregen/SoftwareSerial
  
Home
*/ #include <SoftwareSerial.h> SoftwareSerial mySerial(10, 11); // RX, TX void setup() { // Open serial communications and wait for port to open: Serial.begin(9600); while (!Serial) { ; // wait for serial port to connect. Needed for native USB port only } // set the data rate for the SoftwareSerial port mySerial.begin(9600); } void loop() { // run over and over if (mySerial.available()) { Serial.write(mySerial.read()); } if (Serial.available()) { mySerial.write(Serial.read()); }

This code is to test the connection between the Arduino serial monitor and the device connected to the Bluetooth module.

Liked What You See?​
Get Updates And Learn From The Best​

Leave a Reply

Your email address will not be published. Required fields are marked *