Particle Photon Wi-Fi Module

Particle Photon Wi-Fi Module is a connected development board for Wi-Fi and Internet-enabled projects. It combines a 120Mhz ARM Cortex M3 microcontroller with a Broadcom Wi-Fi chip in a tiny module format. The board includes an RGB LED, Setup and Reset buttons, and headers. It is designed as an over-the-air-programmable ARM Cortex M3 development board. It also supports Soft AP setup and runs a real-time operating system.

Features of Particle Photon Wi-Fi Module - 802.11b/g/n, 1MB, 128KB

• Broadcom BCM43362 Wi-Fi chip
• 802.11b/g/n wireless support
• 120Mhz ARM Cortex M3 CPU
• On-board RGB status LED
• Setup and Reset buttons
• 18 mixed-signal GPIO
• Open-source design
• Soft AP setup
• FCC, CE, and IC certified

Specifications of Particle Photon Wi-Fi Module - 802.11b/g/n, 1MB, 128KB

• Wi-Fi Chip: Broadcom BCM43362
• Wi-Fi: 802.11b/g/n
• CPU: STM32F205RGY6 120Mhz ARM Cortex M3
• Flash: 1MB
• RAM: 128KB
• On-board RGB status LED (ext. drive provided)
• 18 Mixed-signal GPIO and advanced peripherals
• Open-source Design
• Real-time operating system (FreeRTOS)
• Soft AP setup
• FCC, CE, and IC certified
• Size: 43mm x 28mm

How to Use Particle Photon Wi-Fi Module - 802.11b/g/n, 1MB, 128KB

1. Connect the board headers for your project setup.
2. Use the Setup and Reset buttons to change modes as needed.
3. Configure the board for Wi-Fi and Internet connectivity.

More Info

• Includes headers
• No antenna included