Search results for: 'motors to'

Overview In this article, you will learn how to control DC, Stepper, and servo motors by Arduino and L293D. At the end of this tutorial, you should be able to control spinning direction, acceleration, speed, power and shaft position.If you do not know what L293D is, we suggest reading L293D: Theory, Diagram, Simulation & Pinout . Why Driving Motors with L293D? Driving electromotors needs a high current. In addition, spinning direction and speed are two imp...

Overview In this tutorial, you will learn how to drive DC, stepper and servo motors using an Arduino L293D motor driver shield. What You Will Learn General information about DC motors Introduction to L293D motor shield Driving DC, Servo & Stepper motors Motors & Drivers Motors are an inseparable part of many robotics and electronics projects and have different types you can use depending on their application. Here is some information about different...

L298N DC Motor Driver Feature L298N module is used to drive DC motors with a current of less than 2 amps. This module is easy to use. It contains convenient filter circuit and have access to inputs and outputs via pin headers and terminals. The L298N is a dual full-bridge motor driver that allows two DC motors to be connected simultaneously. Note The L298N motor controller follows the H-bridge configuration, so it can be used to drive stepper motors too. This driver needs a logic voltage supply to drive t...

MX1508 Motor Driver Module Features The MX1508 driver is one of the cheapest drivers for running DC motors with a maximum current of 2 amps. Small dimensions and simple setup are the positive features of this module. The MX1508 is a dual full-bridge motor driver that allows two DC motors to be connected simultaneously. Note The MX1508 motor controller follows the H-bridge configuration, which is handy to drive a stepper motors.This driver has a temperature protection circuit that disables the d...

L298N Motor Driver Module Features The L298N module is used to drive DC motors with a maximum current of 2 amps. The L298N driver module is easy to use. It contains a good filter circuit and gives you access access to inputs and outputs via pin headers and terminals. The L298N is a dual full-bridge motor driver that allows two DC motors to be connected simultaneously. Note The L298N motor controller follows the H-bridge configuration, which is handy to drive a stepper motors. This driver needs a logic vo...

YwRobot Vibration Motor Features This small built-in module uses a high-quality vibration motor. You can make some interesting Arduino projects such as an alarm, a notifier or even a vibrating robot! When the input is high, the motor will vibrate just like your cell phone. You can control the ON/OFF or vibration intensity through digital signal or PWM signal.The module adopts a high-quality mobile phone vibration motor; the vibration effect is evident; it is amplified and suitable as a non-audible indic...