Search results for: 'so 2'

SW-520D Vibration Tilt Sensor Features The SW-520 sensor consists of two metal balls which switches as a trigger. When the switch is positioned horizontally, and when the sensor angle is less than 10°, the circuit is open (off state) and more than 10°, it is closed (on stated). But when the switch is positioned vertically, the circuit is open when the sensor angle is less than 45°, and close when the angle is more than 45°. To see exactly how this sensor works, read the datasheet. The SW-520D sensor is ...

TLP281 4-Channel Opto-isolator IC Module Features Sometimes we need to separate the low-voltage section (microcontroller) from the high-voltage one in circuit in order to prevent noise and damage to the microcontroller. This module isolates the low-voltage section from the high-voltage section using TLP281-4 IC. This IC contains 4 LEDs (Light Emitting Diode). 4 high-voltage channels can be controlled by microcontroller using this IC.This module can also be used to turn on and off the servo motor and oth...

LJ12A3-4-Z/BX Inductive Proximity Sensor Features Proximity sensors are used to detect the presence of nearby objects. The LJ12A3-4-Z / BX sensor has three pins, two of which are connected to a supply voltage of 6 to 36 V. The output pin is PNP and NO (Normal Open). That is, it is normally Low and when it detects an object, it becomes HIGH. The detection distance is 4 mm, and it can only detect metal objects such as copper, aluminum, iron, etc. Note Since the operation voltage is more than 5 V,...

TTP223 Capacitive Touch Sensor Features The TTP223 sensor can be used in a variety of applications such as smartphones and tablets. The sensor can recognize objects even from behind glass and thin surfaces. The operating voltage is 2 to 5.5V. The maximum response time is 220 milliseconds. This module has two non-soldered adjustment pins: A and B. The working modes are as follows:A and B both open: The default value of the output pin is LOW. When the sensor is subjected to touch, the output is HIGH, and...

SI7021 Temperature and Humidity Sensor Features The SI7021 humidity and temperature sensor is a CMOS integrated sensor with I2C communication protocol. This sensor is factory calibrated and calibration data is stored in an on-chip non-volatile memory.This sensor is used in various applications such as thermostat and humidistats, respiratory therapy, Indoor weather stations, tablets, mobile phones, etc.Humidity measurement range: 0 to 100%RH - Accuracy 3%RHTemperature measuring range: -40°C to +125°C ...

GY-31 TCS3200 Color Sensor Features The TCS3200 color sensor uses 64 photodiodes to detect color. The output of this sensor is a square wave. Color intensity is obtained directly from the frequency of the square wave. These 64 photodiodes consist of 16 diodes with red filter, 16 diodes with green filter, 16 diodes with blue filter and 16 transparent photodiodes without filter. All 16 diodes of each type are connected in parallel. To detect any color, the photodiodes corresponding to that color are activ...