Search results for: 'ic on'

US-100 Distance Sensor Features The US-100 is an ultrasonic transmitter and receiver module used to measure distance. The sensor operation is very simple. You only need to measure the return time of ultrasonic waves in order to measure the distance. Then you can divide this time by 2 and multiplied by the sound speed. The sensor measuring range is about 2 to 450 cm. Note The US-100 module has 2 different communication protocol. Method 1: use serial communication Method 2: use Trigger and Echo (similar to ...

MAX4466 Module Features The MAX4466 sensor is used to detect ambient sounds. This module has a built-in amplifier. Note The module output is not zero in silent mode and has 1.25V offset. MAX4466 Electret Microphone Pinout This sensor has 3 pins:VCC: Module power supply – 3-5.5 VGND: GroundOUT: Digital output data to the microcontrollerYou can see pinout of this module in the image below. You can download the datasheet of thi...

TM7711 24-bit Pressure Module Features The TM7711 is a 24-bit 2-channel analog-to-digital converter used to measure resistance changes. This module is widely used in load cell and air pressure sensors. This module features high accuracy, quality and cost-effectiveness. Note This module does not support I2C communication. You can download the datasheet of this module here. [wpdm_package id='18020'] TM7711 24-bit Pressure Module Pinout This sensor has 8 pins: VIN: Module power supply – 3.3-5...

MicroDuino Touch Sensor Features This touch button is a simple digital output sensor. It uses the TTP223 chip to detect capacitance change. This sensor features small size, high sensitivity, long power consumption and long lifespan. When the sensor is touched, its output is LOW, otherwise it is HIGH. You can download the datsheet of this module here. [wpdm_package id='19221'] MicroDuino Touch Sensor Pinout This Module has 4 pins: VCC: Module power supply – 3.3 to 5 V GND: Ground OUT: ...

WSN-03 Wireless Module Features This module features:Transmitting and receiving data over long distances (3.5 to 4 km)Operating frequency: 433, 470, 868 and 915 MHzData transfer sensitivity: 120dBmW (decibel-milliwatts)Receiving current: less than 30 mATransmitting current: less than 30 mAsleep mode current: less than 5 mA You can download the datasheet of this module here.[wpdm_package id='19515'] WSN-03 Wireless Module Pinout This Module has 8 pins:3V: Module ...

OMRON Photoelectric Sensor Features The Omran photoelectric sensor can be used to detect obstacles and objects at 5 to 100 mm distance. There is an LED on the sensor that is always off and turns on when it detect an obstacle. You can also change the LED status using the potentiometer which is on sensor. (That is, the LED is always on and will turn off when the obstacle is detected.) There is another potentiometer on the sensor that can be used to change the sensitivity of the sensor (increase or decrease th...

RepRapDiscount Full Graphic Smart Controller Features Using the RepRapDiscount Smart Controller, you don’t need a computer to control 3D printer anymore. In this shield, an SD card is used to transfer 3D design to 3D printer and store the G-Codes. This full graphic Smart Controller contains a 128 x 64 dot matrix LCD display. Using the rotary encoder on the board, you can move around in the device menu and access data. This display is compatible with ramps 1.4 controllers and can be run with marlin and rep...

5 Direction Joystick Button Module Features The 5 direction joystick button module is actually a combination of 5 pushbuttons that can be used in simple games. It is capable of connecting to a variety of microcontrollers. this module has 5 keys: Up, Down, Left, Right, Middle; And two additional keys: Set and Reset. This module works based on a common pin, COM. This means that by pressing each key, the related pin will connect to COM pin. 5 Direction Joystick Button Module Pinout This Module has 8...