Search results for: 'arduino micro ter o'

FC-04 Sound Sensor Features This module consists of a capacitive microphone and an amplifier circuit. The output of this module is analog. This module can be used to measure ambient noise. You can adjust the accuracy of the sensor by using a variable resistor on the device. FC-04 Sound Module Pinout FC-04 module has 3 pins: VCC: Module power supply: 5 V GND: Ground OUT: Module output (Analog) You can see the pinout in the following image. Required Materials Hardware C...

MAX9814 Microphone Module Features Microphone AGC amplifier module, based on MAX9814 chip, has a 2.7V to 5.5V power supply. This device features a built-in low-noise microphone bias. This module can also be connected directly to AUX output. Note The module’s output is not zero in silent mode and has an offset 1.25V. MAX9814 Microphone Module Pinout This module has 5 pins:  VCC: Module power supply – 2.7-5.5 V  GND: Ground  OUT: Analog data output to the microcontroller ...

RCWL-0516 Microwave Radar Sensor Features The RCWL-0516 microwave radar motion detection sensor is used to detect motion at a maximum distance of 9 meters. The viewing angle of this module is about 270 degrees and it has a digital output. You can install a photocell sensor on this module. Note The RCWL-0516 module does not work properly at a distance less than 20 cm. Note This module can measure a maximum distance of 7 meters by default; but you can adjust distance by placing a resistor behind the board. No...

MAX4466 Module Features The MAX4466 sensor is used to detect ambient sounds. This module has a built-in amplifier. Note The module output is not zero in silent mode and has 1.25V offset. MAX4466 Electret Microphone Pinout This sensor has 3 pins:VCC: Module power supply – 3-5.5 VGND: GroundOUT: Digital output data to the microcontrollerYou can see pinout of this module in the image below. You can download the datasheet of thi...

MicroDuino Touch Sensor Features This touch button is a simple digital output sensor. It uses the TTP223 chip to detect capacitance change. This sensor features small size, high sensitivity, long power consumption and long lifespan. When the sensor is touched, its output is LOW, otherwise it is HIGH. You can download the datsheet of this module here. [wpdm_package id='19221'] MicroDuino Touch Sensor Pinout This Module has 4 pins: VCC: Module power supply – 3.3 to 5 V GND: Ground OUT: ...

HW-M10 Microwave Sensor Module Features The HW-M10 microwave sensor module is very accurate and widely used for motion detection in alarm and security systems. This module, like the PIR module, can detect any movement. The only difference is that instead of using radiation emitted by or reflected from objects, it uses microwave Doppler radar technology. This module has a digital output that is normally Low and becomes High (3.3V) if it detects motion and remains High for 2 to 3 seconds. ...

Introduction In the world of microcontrollers, the Micro:bit and Arduino stand out as two popular choices for hobbyists, educators, and professionals alike. Many individuals are seeking insights into the Micro:bit vs. Arduino debate. Both platforms offer unique features and capabilities, but deciding which one is better suited for a particular project can be a daunting task. In this article, we will compare the Micro:bit and Arduino, exploring their strengths, weaknesses, and ideal use c...