Search results for: 'module mic arduino'

FC-04 Sound Sensor Features This module consists of a capacitive microphone and an amplifier circuit. The output of this module is analog. This module can be used to measure ambient noise. You can adjust the accuracy of the sensor by using a variable resistor on the device. FC-04 Sound Module Pinout FC-04 module has 3 pins: VCC: Module power supply: 5 V GND: Ground OUT: Module output (Analog) You can see the pinout in the following image. Required Materials Hardware C...

MAX9814 Microphone Module Features Microphone AGC amplifier module, based on MAX9814 chip, has a 2.7V to 5.5V power supply. This device features a built-in low-noise microphone bias. This module can also be connected directly to AUX output. Note The module’s output is not zero in silent mode and has an offset 1.25V. MAX9814 Microphone Module Pinout This module has 5 pins:  VCC: Module power supply – 2.7-5.5 V  GND: Ground  OUT: Analog data output to the microcontroller ...

MAX4466 Module Features The MAX4466 sensor is used to detect ambient sounds. This module has a built-in amplifier. Note The module output is not zero in silent mode and has 1.25V offset. MAX4466 Electret Microphone Pinout This sensor has 3 pins:VCC: Module power supply – 3-5.5 VGND: GroundOUT: Digital output data to the microcontrollerYou can see pinout of this module in the image below. You can download the datasheet of thi...

HW-M10 Microwave Sensor Module Features The HW-M10 microwave sensor module is very accurate and widely used for motion detection in alarm and security systems. This module, like the PIR module, can detect any movement. The only difference is that instead of using radiation emitted by or reflected from objects, it uses microwave Doppler radar technology. This module has a digital output that is normally Low and becomes High (3.3V) if it detects motion and remains High for 2 to 3 seconds. ...