ST-Link V2/JTAG Programmer for STM8 & STM32 (Without ID)

100 % of 100
Availability: Out of stock
+25 4 % $12.96
+50 6 % $12.69
+100 8 % $12.42
+300 10 % $12.15
+500 12 % $11.88
Related Products

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module and JTAG/serial wire debugging interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. STM8 applications use the USB full speed interface to communicate with STMicroelectronics' ST Visual Develop or ST Visual Program software. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.


  • 5V power supplied by a USB connector
  • USB 2.0 full speed compatible interface
  • USB standard A to mini B cable
  • Programming: Programs FLASH ROM, EEPROM, AFR, Security-bits, etc.
  • Operating temperature 0 to 50°C
  • SWIM specific features
  • 1.65V to 5.5V application voltage supported on SWIM interface
  • SWIM low-speed and high-speed modes supported
  • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
  • SWIM cable for connection to the application via an ERNI standard vertical or horizontal connector
  • SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
  • JTAG specific features
  • 1.65V to 3.6V application voltage supported on the JTAG interface and 5 V tolerant inputs
  • JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
  • Direct firmware update feature supported
  • Status LED which blinks during communication with the PC
  • Supported Devices
  • Supports all STM8 MCU interfaces with SWIM
  • Supports all STM32 family of microcontrollers with JTAG / SWD interface
  • ST-LINK/V2 Status
  • The LED labeled 'COM' on top of the ST-LINK/V2 shows the ST-LINK/V2 status (whatever the connection type).
  • When the LED is blinking RED: the first USB enumeration with the PC is taking place. If it keeps blinking RED, maybe the USB driver is NOT found
  • LED is RED: communication between ST-LINK/V2 and the PC is established , end of enumeration
  • LED is blinking GREEN/RED: data are being exchanged between the target and the PC
  • LED is GREEN: the last communication has been successful
  • LED is ORANGE: ST-LINK/V2 communication with the target has failed


Write Your Own Review
You're reviewing:ST-Link V2/JTAG Programmer for STM8 & STM32 (Without ID)
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?